|
[Sponsors] |
July 27, 2006, 16:31 |
Negative Jacobian
|
#1 |
Guest
Posts: n/a
|
Hi,
I wonder if you can help me here. I have created a body-fitted mesh inside a circular nozzle where I have some negative jacobians, I dont undertand how I can remove these negative jacobian. These happens if I increase the mesh points. Thanks in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
negative element volume (CFX-10.0) | CFDworker | CFX | 8 | September 27, 2011 18:16 |
channelFoam for a 3D pipe | AlmostSurelyRob | OpenFOAM | 3 | June 24, 2011 13:06 |
blockMesh error ... | balkrishna | OpenFOAM Pre-Processing | 0 | August 17, 2010 02:39 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |