|
[Sponsors] |
November 19, 2013, 07:59 |
Mesh Requirements for Heat Transfer?
|
#1 |
New Member
Join Date: Sep 2013
Posts: 4
Rep Power: 12 |
Hey,
I was wondering how i can approximate the mesh size for a CHT Problem. I have a rotor and i want to simulate the heat transfer in the casing of the rotor. Are there any quality or other requirements for the mesh in the solid casing? and what is a good starting point to decide what size the mesh in the casing should have in comparison to the boundary layer of the rotor domain? cheers |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Two-sided Wall Heat Transfer BC - No Separate Solid Mesh and No Heat Transfer Coeff | swahono | OpenFOAM Running, Solving & CFD | 10 | October 15, 2018 05:43 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |