|
[Sponsors] |
February 6, 2014, 08:49 |
Regarding applying periodic boundaries
|
#1 |
New Member
Ahirekar Prasanna P
Join Date: Aug 2013
Posts: 15
Rep Power: 12 |
hii guys,
I am simulating a 20 degree sector of a combustor in fluent.I want to apply periodic boundaries at the enclosing faces but fluent is giving following message warning-differing no of faces on these threads zone 2439 - matched 0 out of 37489 faces zone 2453 - matched 0 out of 38312 faces so please tell me how to proceed further. Also fluent asks periodic zone and shadow zone so what is meaning of this shadow zone. thank you in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Periodic boundaries in two directions | jphastings | ANSYS | 3 | January 14, 2022 06:06 |
[ICEM] Can I define periodic boundaries in an unstructured mesh? | Aoki | ANSYS Meshing & Geometry | 11 | September 14, 2018 01:52 |
Why can't I make the boundaries periodic? | Alina | FLUENT | 5 | April 12, 2012 14:06 |
periodic boundaries - flow through a net | PK | FLUENT | 0 | July 12, 2007 11:58 |
Periodic Boundaries in GAMBIT!! | swetha | FLUENT | 1 | November 26, 2006 22:02 |