|May 27, 2014, 07:00||
Join Date: Nov 2010
Posts: 9Rep Power: 7
I am trying to simulate a room which is to be maintained at a negative pressure with respect to the outside conditions i.e. supply<extract to ensure inward leakage through the building fabric. Can you please suggest any way of achieving this? I am aware that mass has to be balanced within the simulation.
So if I lower the extracts to the supply levels, assuming that supply is not less than extract by a few percentage points, will it achieve a fairly similar effect.
|building, extract, negative, pressurisation, supply|
|Thread||Thread Starter||Forum||Replies||Last Post|
|non-orthogonal faces and incorrect orientation?||nennbs||OpenFOAM Native Meshers: blockMesh||7||April 17, 2013 05:42|
|error message with modeling a cube with a hold at the center||hsingtzu||OpenFOAM Native Meshers: blockMesh||2||March 14, 2012 10:56|
|mesh airfoil NACA0012||anand_30||OpenFOAM Meshing & Mesh Conversion||12||December 12, 2011 05:16|
|BlockMesh FOAM warning||gaottino||OpenFOAM Native Meshers: blockMesh||7||July 19, 2010 14:11|
|Axisymmetrical mesh||Rasmus Gjesing (Gjesing)||OpenFOAM Native Meshers: blockMesh||10||April 2, 2007 14:00|