|September 12, 2001, 06:07||
ANSYS/Flotran GUI/bc problems
I have a serious problem with GUI using ANSYS/Flotran module (Ansys 5.6.1). I can not set velocity boundary conditions to lines or nodes. All I get is a error message:
Invalid character in parameter name. The setting of parameter= 101 is ignored.
Setting bc:s on areas works normally, as does setting of the bc manually (DL,,,,,,)
Does anyone have ideas, patches or links to help sites?
PS. Here are the DL commands that the GUI produces:
DL,_Y1,,VX,1,1 DL,_Y1,,VY,0,1 DL,_Y1,,VZ,0,1
These are definately wrong, the _Y1 should be a number of the line.
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] Problems with coedge curves and surfaces||tommymoose||ANSYS Meshing & Geometry||0||August 5, 2011 16:02|
|Needed Benchmark Problems for FSI||Mechstud||Main CFD Forum||4||July 26, 2011 12:13|
|Help required to solve Hydraulic related problems||aero||CFX||0||October 30, 2006 12:00|
|Some problems with Star CD||Micha||CD-adapco||0||August 6, 2003 13:55|
|Using Fluent for Geophysical Problems||Hassid Samuel||FLUENT||0||February 23, 2001 07:04|