|April 25, 2009, 15:43||
How can define interface between solid and Fluid?
Join Date: Apr 2009
Posts: 140Rep Power: 9
I have a problem in which a heater is on leading edge of an airfoil and this airfoil is placed in Icing wind tunnel. Air is inside the tunnel at -5C. And water spray by using atomizer is also there.
I have to figure out how many water droplet impact on edge.
Could you tell me which model should i use?
Currently i am using (Eulerian+Discrete phase model).
I don't have any clue please guide me.
Secondly, how can i define interface between Heater and Fluid(Airfoil wall)?
It is very urgent.
Many Many thanks in advance.
|Thread||Thread Starter||Forum||Replies||Last Post|
|How can define interface between solid and Fluid?||Saima||FLUENT||10||May 5, 2009 06:09|
|Boundary conditions at Fluid Solid interface (CHT)||michelle||CFX||1||April 21, 2008 04:06|
|Convective Heat Transfer - Heat Exchanger||Mark||CFX||6||November 15, 2004 16:55|
|UDFs for Scalar Eqn - Fluid/Solid HT||Greg Perkins||FLUENT||0||October 13, 2000 23:03|
|UDFs for Scalar Eqn - Fluid/Solid HT||Greg Perkins||FLUENT||0||October 11, 2000 03:43|