Good litterature? CWE

Martin_K · June 16, 2010, 06:18

Hello All,

I am new to both this forum and the interesting field of CFD.
I have been working a bit with gambit and fluent with some rather simple simulations.
In relation to this, I have tried to find some decent litterature on the topic, but have not quite found what I was looking for in the litterature I have as of yet encountered.

Can anyone suggest good litterature (preferable in English) covering:

-Simulation of wind flows around buildings with application to determination of (~accurate) pressure fields on facades of buildings.

The books I have been able to dig up so far, are most rather old (approximately the 1980's).

Any suggestions would be appriciated.

julien.decharentenay · June 16, 2010, 18:10

Did you look at ASHRAE publications?

June 16, 2010, 06:18	Good litterature? CWE	#1
Martin_K New Member Martin Kuæd Join Date: Jun 2010 Posts: 1 Rep Power: 0	Hello All, I am new to both this forum and the interesting field of CFD. I have been working a bit with gambit and fluent with some rather simple simulations. In relation to this, I have tried to find some decent litterature on the topic, but have not quite found what I was looking for in the litterature I have as of yet encountered. Can anyone suggest good litterature (preferable in English) covering: -Simulation of wind flows around buildings with application to determination of (~accurate) pressure fields on facades of buildings. The books I have been able to dig up so far, are most rather old (approximately the 1980's). Any suggestions would be appriciated.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how iam determine good quality of mesh grid of airfoil using gambit	nuimlabib	FLUENT	2	June 29, 2009 08:11
How to do a good geometry clean-up in GAMBIT	mahadevan.swamy	Main CFD Forum	0	June 19, 2009 21:13
Good convergence but without a good heat balance	Juan Martin CatelÃ©n	CFX	4	June 27, 2007 18:41
[blockMesh] Is blockMesh generally considered a good quality tool	york	OpenFOAM Meshing & Mesh Conversion	4	November 15, 2006 13:42
A good question about UDS	Z	FLUENT	1	March 31, 2005 15:14

June 16, 2010, 18:10		#2
julien.decharentenay Senior Member Julien de Charentenay Join Date: Jun 2009 Location: Australia Posts: 231 Rep Power: 17	Did you look at ASHRAE publications?