|July 27, 2011, 06:35||
hot free jet : which parameters?
Join Date: Jul 2011
Posts: 1Rep Power: 0
I'm am currently trying to simulate a hot free jet of air in 2D axis-symetric using ANSYS Fluent. The speed is around 50m/s and the hole radius 5mm. Temperature of the jet is 523K and ambiant air is 333K.
I have done quite a few simulations testing the influence of a change in the solver, mesh, compressibility of the flow,etc, and though the results aren't abberant there are always quantitative differences in the velocity and temperature profiles (most disturbing being mesh dependency).
Which physical and numerical setup best simulates this case?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Free water jet impinging hot solid surface, including boiling||hamdy||Fluent UDF and Scheme Programming||5||August 19, 2012 20:52|
|Help!simulation of free water jet||Annie||FLUENT||3||June 29, 2009 01:51|
|Free jet||Til Haendler||FLUENT||1||September 12, 2001 11:39|
|Asymmetric water free jet study||Norberto Parreira||Main CFD Forum||7||June 25, 2001 09:23|
|Radial jet with free surface using FIDAP||Dr. Ahmed Hassaneen||Main CFD Forum||0||October 28, 1999 14:20|