|July 31, 2011, 10:10||
forward curve centrifugal blower boundary condidions
Hi friends, I have a problem about simulation of a forward curve centrifugal blower 3D due to blade motionless
1- Blades don't rotate in rotating zone thus the flow is complex around blades, some fluid flows in the back direction interestingly
2- when I change moving referance frame to moving mesh, the fluid flows in right direction but blades don't rotate again
3- To sum up, I suspect either the blades don't rotate anytime because of flow is rotate (but there are some simulations when a examine in the google) or I have a problem about rotating zone
Do you have any idea about this problem?
Thanks for your interest, primarily!
Last edited by m.salih; August 1, 2011 at 03:40.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Implementation of boundary conditions for FVM||Tom||Main CFD Forum||7||August 26, 2014 05:58|
|Water subcooled boiling||Attesz||CFX||7||January 5, 2013 04:32|
|CENTRIFUGAL PUMP, characteristic curve||Ivanrips||CFX||4||September 14, 2010 10:29|
|centrifugal compressor boundary condition||nuimlabib||Main CFD Forum||0||June 25, 2010 17:43|
|Boundary conditions?||Tom||Main CFD Forum||0||November 5, 2002 02:54|