|
[Sponsors] |
June 4, 2005, 03:33 |
solidification problem
|
#1 |
Guest
Posts: n/a
|
Dear friends,
I am dealing with a solidification problem, where indial test case is run with a closed domain without any outlet, considering the flow to be compressible. I am solving this problem as a multiphase problem .I press the mould through the inlet which is considered incompressible. Already i have air present inside which i consider it as a compressible. Is it possible to model this case as a hybrid ( both compressible and incompressible)? As of now, i dont take any temperature effects into consideration. I am trying to analyse the flow nature with pressure distributions. Or i should take the case of solving it as a compressible flow problem? Kindly clarify Thanks in advance Karthik |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
area does not match neighbour by ... % -- possible face ordering problem | St.Pacholak | OpenFOAM | 10 | February 7, 2024 21:50 |
conduction problem | venkataramana | OpenFOAM | 3 | December 1, 2013 07:30 |
Problem Importing Geometry ProE to CFX | fatb0y | CFX | 3 | January 14, 2012 19:42 |
Problem in modeling solidification | S. Balasubramanyam | CFX | 0 | January 20, 2004 09:54 |
Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |