|
[Sponsors] |
August 15, 2005, 14:20 |
Multiple inlets problem
|
#1 |
Guest
Posts: n/a
|
Hello, all
I was doing a gas-liquid modelling work in which multiple inlets were invloved. These inlets are actually bubble diffusers and I totally have 100 of them. Can someone give me some suggestions on how to handle these multiple inlets(in view of mesh, turbulence model, and boundary conditions so on)? Is it the same as to treat a single inlet? The geometry of my problem is simple, just a tank with several baffles and liquid comes from one side flow out other side. The gas is input from the bottom before first baffle. Thanks for your inputs! Best regards! Jeff |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
problem with surface creation in ICEM from multiple curves | dialolema | ANSYS Meshing & Geometry | 2 | October 27, 2014 13:14 |
OpenFOAM static build on Cray XT5 | asaijo | OpenFOAM Installation | 9 | April 6, 2011 12:21 |
Is it possible to have multiple velocity inlets in your model | boundarylayer | FLUENT | 0 | June 5, 2010 02:29 |
Velocity profiles problem behind the elbow (3D problem) | kabat73 | FLUENT | 8 | May 9, 2010 04:26 |
Multiple Sahdows / Periodicity Problem | Michael Pi | FLUENT | 0 | July 11, 2005 07:42 |