|October 7, 2013, 04:46||
Improve Grid Quality with Autogrid
Join Date: Oct 2013
Posts: 4Rep Power: 4
Iam a beginner in using numeca/autogrid. I have to apply hub fillets at a given geometry. I imported the geometry successfully and applied hub fillets with different radius.
Unfortunalley the grid quality, mainly the min. skewness, is quite bad. iam trying to reach angles about 22 grad but by increasing the radius the min. skewness is getting worse.
My question is: How can I increase the skewness angle and the quality? Are there any tools in autogrid?
I would be very thankful about your help!
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] Quality problem adjusting grid with y+||earth07||ANSYS Meshing & Geometry||1||July 24, 2013 11:07|
|[ICEM] Hex refinement negative quality afterwards||Anorky||ANSYS Meshing & Geometry||8||March 22, 2010 04:25|
|Improve smoothness & quality of structured grid||quarkz||Main CFD Forum||2||March 10, 2007 16:26|
|Combustion Convergence problems||Art Stretton||Phoenics||5||April 2, 2002 05:59|
|Algebraic Multigrid for nonuniform grid||Joshua Lee||Main CFD Forum||4||March 16, 2000 14:05|