|
[Sponsors] |
September 30, 2015, 07:49 |
stacking problem in autoblade
|
#1 |
New Member
cheekoo
Join Date: Sep 2015
Posts: 4
Rep Power: 10 |
Hi,
Attached is a geomturbo file for a stator blade. The blade sections (untwisted) need to be stacked along the vector radius through the center of the throats, i.e center of channel in autoblade. But when i initialize with 'stacking law = center of channel', i get following errors. ''failed to extract stacking data Failed to project the target geometry on parametric stream surfaces'' Kindly advise how to solve this problem. Thank you. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] engineFoam new mesh problem | ayhan515 | OpenFOAM Meshing & Mesh Conversion | 5 | August 10, 2015 08:45 |
UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |