CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > NUMECA

Rotor 37

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   April 9, 2004, 03:11
Default Rotor 37
  #1
sunshine
Guest
 
Posts: n/a
i give the value of k and e like this :114.84375,1619396.7 ,which is caculated in line with the formulation of the NUMECA menu.i am not sure where the problem lies in ,mesh or the boundary conditions.when it runs to the fine mesh ,it just appears the information that reads pressure negative and density negative .
  Reply With Quote

Old   April 9, 2004, 22:26
Default Re: Rotor 37
  #2
xingenlu
Guest
 
Posts: n/a
I think it is the problem of mesh,maybe you should check the quality of the mash such as orthogonality,Aspect ratio, expansion ratio and so on,I have met such problem,good lucky.
  Reply With Quote

Old   April 12, 2004, 09:58
Default Re: Rotor 37
  #3
sunshine
Guest
 
Posts: n/a
thank you a lot !i then try it .i appreciate your kindness.
  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Did anybody run he ROTOR 67 by using CFX? MouseInMilk CFX 0 August 30, 2006 18:37
Rotor 37 Max MIheev Main CFD Forum 1 October 12, 2005 14:05
rotor 37 sunshine NUMECA 2 October 1, 2004 04:29
about rotor 37 sunshine NUMECA 1 June 2, 2004 08:38
rotor 37 sunshine NUMECA 0 April 6, 2004 21:21


All times are GMT -4. The time now is 20:31.