how to deremine boundary layer height? -- CFD Online Discussion Forums

April 5, 2006, 05:22	how to deremine boundary layer height?	#1
Mike Guest Posts: n/a	I have faecd a fact that from manual thet when u are going to capture near wall region you have to refine mesh at near wall region ,and your y plus should be in limit of 11.In your boundary layer there should be 10 nodes.but how to determine this hight.i.e. there should be these much nodes in this hight so that we can mesh according to that. Thaks in advance.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Height of boundary layer	DAK565656	CFX	2	April 19, 2007 11:30
how to deremine boundary layer height?	Mike	Phoenics	2	March 7, 2007 12:47
how to deremine boundary layer height?	Mike	CFX	5	April 6, 2006 08:15
how to deremine boundary layer height?	Mike	Siemens	1	April 5, 2006 10:47
how to deremine boundary layer height?	Mike	FLUENT	1	April 5, 2006 09:34

All times are GMT -4. The time now is 01:10.