 |
 |
 |
|
|
|
[Sponsors] | ||||
July 17, 2009, 05:53
|
sample/functions surface with refinement
|
#1 |
|
Senior Member
Fabian Braennstroem
Join Date: Mar 2009
Posts: 407
Rep Power: 8  |
Hi,
there is a problem with sample surface and the use of surfaces with 'libsampling'. No datas are written to the vtk file in the region of previously refined mesh; e.g. it does not work for the pitzDaily case with a refineHexMesh based on a selected cellSet. Regards! Fabian |
|
|
|
|
|
July 17, 2009, 07:24
|
|
#2 |
|
Super Moderator
Mattijs Janssens
Join Date: Mar 2009
Posts: 1,416
Rep Power: 13 |
I just tried 1.5.x with a 3D 'cavity'. Time 0 .. 0.3 are normal, time 0.305 has some cells refined. Put a 'constantPlane' through the refinement. All looks ok.
|
|
|
|
|
|
|
July 30, 2009, 02:02
|
|
#3 |
|
Senior Member
Fabian Braennstroem
Join Date: Mar 2009
Posts: 407
Rep Power: 8 |
Hi Mattijs,
sorry, I was not up to date... I just tested it on 1.6. Thanks! Fabian |
|
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| boundaries with gmshToFoam | ouafa | Open Source Meshers: Gmsh, Netgen, CGNS, ... | 7 | May 21, 2010 12:43 |
| snappyHexMesh - Floating point error | derjames | OpenFOAM Mesh Utilities | 4 | September 19, 2009 14:14 |
| Error : Self intersecting surface mesh, computing intersections & Error : Impossible | velan | Open Source Meshers: Gmsh, Netgen, CGNS, ... | 0 | June 29, 2009 00:48 |
| Problem with Gmsh | nishant_hull | Open Source Meshers: Gmsh, Netgen, CGNS, ... | 17 | December 7, 2007 01:33 |
| CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |
Linear Mode
