cgnsToFoam bug for incompressible pressure

lentschi · March 16, 2011, 09:50

Hello,

during transformation from cgns to foam I found a bug in the cgnsToFoam tool, especially in the transformed incompressible pressure.
cgnsToFoam creates a p-file and changes the unit from Pa to m²/s² perfectly but does not divide the entries by rho.
I have confirmed it by comparing the entries of the 0/p-file with CFX-data in post - and they are identical!

Afterwards I started a calculation without the results of cgns and now the calculated p-file contains the correct entries.

Regards Markus

lentschi · March 17, 2011, 04:32

Sorry,I have not seen the option -rho!

March 16, 2011, 09:50	cgnsToFoam bug for incompressible pressure	#1
lentschi Member sirLentschi Join Date: Nov 2010 Posts: 86 Rep Power: 15	Hello, during transformation from cgns to foam I found a bug in the cgnsToFoam tool, especially in the transformed incompressible pressure. cgnsToFoam creates a p-file and changes the unit from Pa to m²/s² perfectly but does not divide the entries by rho. I have confirmed it by comparing the entries of the 0/p-file with CFX-data in post - and they are identical! Afterwards I started a calculation without the results of cgns and now the calculated p-file contains the correct entries. Regards Markus

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Calculation of the Governing Equations	Mihail	CFX	7	September 7, 2014 06:27
Setup/monitor points of pressure and force coefficients	siw	CFX	3	October 22, 2010 06:07
Operating condition in Fluent	MASOUD	FLUENT	3	September 16, 2010 17:50
Bug in 1.5-dev buoyantFoam - static pressure	marupio	OpenFOAM Running, Solving & CFD	1	March 17, 2010 09:13
Setting pressure and velocity in inlet	Asghari	FLUENT	5	September 22, 2006 13:23

March 17, 2011, 04:32		#2
lentschi Member sirLentschi Join Date: Nov 2010 Posts: 86 Rep Power: 15	Sorry,I have not seen the option -rho!