[aylalisa]

Hi,

I've up-graded OpenSUSE to version 13.1.
and OpenFoam to version 2.2.2


I receive following error message once I try to start the calculation with mpirun:

It looks like opal_init failed for some reason; your parallel process is
likely to abort. There are many reasons that a parallel process can
fail during opal_init; some of which are due to configuration or
environment problems. This failure appears to be an internal failure;
here's some additional information (which may only be relevant to an
Open MPI developer):

opal_shmem_base_select failed
--> Returned value -1 instead of OPAL_SUCCESS
--------------------------------------------------------------------------
--------------------------------------------------------------------------
It looks like orte_init failed for some reason; your parallel process is
likely to abort. There are many reasons that a parallel process can
fail during orte_init; some of which are due to configuration or
environment problems. This failure appears to be an internal failure;
here's some additional information (which may only be relevant to an
Open MPI developer):

opal_init failed
--> Returned value Error (-1) instead of ORTE_SUCCESS

With the old combination:
OpenSuse 12.2/OF 2.2.1 I didn't face that problem.

How can help?
Where else could I post that problem?
At the moment I am not able to run my calculations in parallel.


The version I use and that makes the trouble:

mpirun --version
mpirun (Open MPI) 1.7.2

OpenFoam /etc/bashrc/
export WM_MPLIB=SYSTEMOPENMPI


The version in the ThirdParty-2.2.2 folder
openmpi-1.6.3
I've changed WM_MPLIB=OPENMPI, sourced ~/.bashrc, checked $FOAM_MPI=1.6.3 and tried to start parallel run.
Same error message!


I've just found the existing thread to the same topic:
post428368http://www.cfd-online.com/Forums/ope...tml#post428368
Sorry' that I've opened a new one!
I've tried to solve the problem accordingly but unsuccessfully!




Please help!!!


Aylalisa