 |
 |
 |
|
|
|
[Sponsors] | ||||
April 27, 2012, 11:10
|
default patches problem
|
#1 |
|
Senior Member
sivakumar selvaraju
Join Date: Mar 2009
Location: India
Posts: 205
Rep Power: 18   |
Hello everyone,
I am generating mesh for one fourth of the cylinder with cyclic boundary condition, the quarter cylinder has 4 blocks, while executing blockMesh, it is generating mesh with some warning. I tried so many times but, i am not able to find the problem. I have attached the blockMeshDict file please have a look and help me to sort out this issue. with regards, Sivakumar |
|
|
|
|
|
May 1, 2012, 04:53
|
|
#2 |
|
Senior Member
sivakumar selvaraju
Join Date: Mar 2009
Location: India
Posts: 205
Rep Power: 18 |
Hello Guys,
Until now there is no reply for this issue, however I have solved the problem. the problem was blocks, the geometry had 4 blocks, now changed in to 6 blocks. now the the problem has been solved. I have attached the blockMeshDict and the mesh output. (old and new) please have a look. with regards, Sivakumar |
|
|
|
|
|
|
May 1, 2012, 05:04
|
|
#3 |
|
Senior Member
sivakumar selvaraju
Join Date: Mar 2009
Location: India
Posts: 205
Rep Power: 18 |
Hello Guys,
Until now there is no reply for this issue, however I have solved the problem. the problem was blocks, the geometry had 4 blocks, now changed in to 6 blocks. now the the problem has been solved. I have attached the blockMeshDict and the mesh output. (old and new) please have a look. with regards, Sivakumar |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [mesh manipulation] stitch mesh - problem with boundary | student666 | OpenFOAM Meshing & Mesh Conversion | 1 | June 19, 2014 12:26 |
| Problem with inconsistent patches (AMI, interDyMFoam) | jrrygg | OpenFOAM Running, Solving & CFD | 3 | February 1, 2013 03:23 |
| CFX-Pre problem, pls help!!! | cth_yao | CFX | 0 | February 17, 2012 00:52 |
| [Commercial meshers] Handling cyclic BC from gambit to openfoam for a cascade airfoil problem - OF 1.6 | maverick | OpenFOAM Meshing & Mesh Conversion | 2 | June 18, 2011 04:36 |
| Problem with Automatic Default Interfaces | jehan | CFX | 1 | June 15, 2010 10:11 |
1Likes
Linear Mode
