|
[Sponsors] |
[mesh manipulation] MakeAxialMesh for flow between two cylinders |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 27, 2012, 03:54 |
MakeAxialMesh for flow between two cylinders
|
#1 |
Member
ali jafari
Join Date: Sep 2012
Posts: 50
Rep Power: 13 |
hi
I solved flow between two cylinders by COMSOL and now I'll do it by OF (I am beginner). I want to use makeaxialmesh utility and Gambit but I dont know define -axis for makeaxialmesh (red line in pictures)!! do I need to do something on gambit model ? please guide me Regards Last edited by ali jafari; September 28, 2012 at 03:23. |
|
September 28, 2012, 08:54 |
|
#2 | |
Assistant Moderator
Bernhard Gschaider
Join Date: Mar 2009
Posts: 4,225
Rep Power: 51 |
Quote:
Just one remark: you might prefer creating a quad-mesh instead of the triangles (and BTW: gambit is a bit of an overkill for that geometry)
__________________
Note: I don't use "Friend"-feature on this forum out of principle. Ah. And by the way: I'm not on Facebook either. So don't be offended if I don't accept your invitation/friend request |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Flow Around four cylinders in square configuration | shzinwoyk | Main CFD Forum | 1 | April 13, 2015 16:44 |
Problem with building geometry - concentric cylinders | Rhoddwen | OpenFOAM Pre-Processing | 9 | December 17, 2014 10:02 |
Problem with geometry - concentric cylinders | Rhoddwen | OpenFOAM Running, Solving & CFD | 0 | December 15, 2014 09:22 |
2D Aerofoil with rotating cylinders - Help & Advice! | Bluejay | OpenFOAM | 1 | December 31, 2012 04:40 |
[mesh manipulation] makeAxialMesh - installation issues | simulator4711 | OpenFOAM Meshing & Mesh Conversion | 3 | March 21, 2012 07:59 |