|
[Sponsors] |
November 2, 2015, 05:48 |
Perforated plate base
|
#1 |
New Member
Ahmed
Join Date: Aug 2015
Posts: 1
Rep Power: 0 |
Dear Foamers,
I am new at openFoam and I'm trying to mesh the base of a cylinder which is a perforated plate as attached. How can I make the holes as a patch and the other walls as a different patch. I'm using blockMesh. Thanks in advance. Last edited by Al-Akaishi; November 2, 2015 at 08:01. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] How to define to right point for locationInMesh | Mirage12 | OpenFOAM Meshing & Mesh Conversion | 7 | March 13, 2016 14:07 |
[mesh manipulation] Importing Multiple Meshes | thomasnwalshiii | OpenFOAM Meshing & Mesh Conversion | 18 | December 19, 2015 18:57 |
Modeling of perforated plate for 3 phase fluidized | Sanyo | FLUENT | 5 | March 27, 2015 11:01 |
Need help on perforated plate with less than 2% open area | sosososo1114 | FLUENT | 9 | August 31, 2011 01:33 |
turbulence at a porous jump (perforated plate) | andrew | FLUENT | 1 | May 8, 2004 09:51 |