|
[Sponsors] |
December 19, 2011, 05:56 |
problems with forces
|
#1 |
New Member
charles badoe
Join Date: Nov 2011
Location: southampton
Posts: 17
Rep Power: 14 |
Hi foamers i am a newbie to OF and trying to use SHM to mesh an airfoil (naca0012). my cd is within range but cl is far from the experimental results. i am using spalart almaras turbulence model. can any one please give me any suggestions why my lift is way off.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Forces on cylinder in Openfoam | krsp | OpenFOAM Post-Processing | 29 | April 8, 2017 11:05 |
Propeller tutorial with air instead of water | JShnyder | OpenFOAM Running, Solving & CFD | 16 | July 31, 2016 20:05 |
Forces in V1.6 | terrybarnaby | OpenFOAM Post-Processing | 72 | September 2, 2015 16:49 |
forces using OpenFOAM-1.6-ext | ebah6 | OpenFOAM Running, Solving & CFD | 0 | June 13, 2012 20:16 |
Two-phase air water flow problems by activating Wall Lubrication Force | challenger85 | CFX | 5 | November 5, 2009 05:44 |