|
[Sponsors] |
February 14, 2015, 09:15 |
BCs for 3-D T-pipe
|
#1 |
New Member
songbo
Join Date: Feb 2015
Posts: 4
Rep Power: 11 |
Hi,
A mesh has been created successfully in Salome (inlet,outlet and walls, they are all patches in polymesh/boundary file) and now I am struggling with the 0/p,u,alphat, etc. files. The mesh is a T-pipe, is it necessary to set cyclic as boundary type, or wall also OK? What about the inlet and outlet type if in turbulent conditions? could anyone help me? BEST REGARDS |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
BCs for bifurcated pipe | Many | OpenFOAM Pre-Processing | 0 | March 23, 2014 09:53 |
pipe flow with noozle - ? on BC's | mediode | Main CFD Forum | 2 | March 14, 2011 10:31 |
BCs in an FSI simulation of a flexble pipe | vivekcfd | OpenFOAM | 10 | January 8, 2010 04:14 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |
fluid flow fundas | ram | Main CFD Forum | 5 | June 17, 2000 21:31 |