 |
 |
 |
|
|
|
[Sponsors] | ||||
February 18, 2009, 09:58
|
Internal boundaries
|
#1 |
|
New Member
Gareth
Join Date: Mar 2009
Posts: 24
Rep Power: 17  |
Is it possible/easy to implement internal boundaries using blockMesh? I would like to model a hollow duct suspended in a flow, so it requires a few 'walls' to have cells on both sides, and it appears that this is not allowed. Does anyone know of a way round it?
Thanks Gareth |
|
|
|
|
|
February 18, 2009, 11:29
|
could you post a sketch?
|
#2 |
|
Senior Member
Wolfgang Heydlauff
Join Date: Mar 2009
Location: Germany
Posts: 136
Rep Power: 21 |
could you post a sketch?
|
|
|
|
|
|
|
February 19, 2009, 03:57
|
Here you go!
Cheers
Gare
|
#3 |
|
New Member
Gareth
Join Date: Mar 2009
Posts: 24
Rep Power: 17 |
Here you go!
Cheers Gareth http://lh5.ggpht.com/_fdWk3HSvzHc/SZ0ev9xc1cI/AAAAAAAAD3Y/NbVpk4rvgBc/duct%20ske tch.PNG |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Possible to create cyliner baffle (internal) using topoSet or stl Mesh? | keepfit | OpenFOAM | 4 | February 19, 2017 14:40 |
| Create an internal face | aylalisa | OpenFOAM Pre-Processing | 1 | June 19, 2013 12:02 |
| [Workbench] Named selection for internal face not appearing in CFX-Pre | francis1 | ANSYS Meshing & Geometry | 0 | April 21, 2013 09:22 |
| [Commercial meshers] Fluent Mesh to OpenFoam: Internal Surface has to be a wall | sebastian | OpenFOAM Meshing & Mesh Conversion | 6 | October 21, 2010 04:36 |
| mapFields : internal edges | Gearb0x | OpenFOAM Running, Solving & CFD | 3 | April 19, 2010 09:02 |
Linear Mode
