|
[Sponsors] |
[Other] Recommendation regarding quarter symmetric meshes |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 29, 2016, 06:22 |
Recommendation regarding quarter symmetric meshes
|
#1 |
Senior Member
Join Date: Oct 2013
Posts: 397
Rep Power: 18 |
I have a geometry which is axisymmetric in 4 quarters. What is the recommended way for meshing this and what boundary conditions are appropriate? Should I use wedge or symmetryPlane?
Is it reasonable to create a wedge-like mesh but with more cells in the angular direction to have better alignment of the cells with the radial flow direction? Does it hurt to have wedge cells at the center axis? Last edited by chriss85; March 29, 2016 at 09:33. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mapping (interpolation) between two meshes | Ebrahim | OpenFOAM Programming & Development | 2 | June 15, 2020 13:31 |
How can I put the data of adpated meshes on the original unadapted meshes? | xh110120 | FLUENT | 2 | March 11, 2016 02:00 |
[ANSYS Meshing] Identical meshes in symmetric bodies in multibody part. | aarvay | ANSYS Meshing & Geometry | 2 | May 11, 2012 11:15 |
[ICEM] Quarter O-grid from vertices and !!!!!! Why? | Far | ANSYS Meshing & Geometry | 13 | March 13, 2012 07:53 |
Getting prism to inflate into mixed tet-hex meshes | Joe | CFX | 16 | October 10, 2011 07:06 |