|July 27, 2007, 08:42||
Hi when I run a MRFSimpleFoa
Join Date: Mar 2009
Posts: 23Rep Power: 8
when I run a MRFSimpleFoam case with cyclic boundary conditions (rotational periodicity), I can not plot the patches of the cyclic boundaries in paraview. They are empty. If I change the boundary conditions to e.g. wall or i include them into the MRFZones then I can see them. It don't care if I can see them or not in paraview, the only thing is, i get insecure if the boundaries are adapted correct.
Has somebody there had the same experience?
|Thread||Thread Starter||Forum||Replies||Last Post|
|MRFSimpleFoam amp cyclic patches||david||OpenFOAM Running, Solving & CFD||36||October 21, 2008 21:55|
|cyclic boundaries||Zealouk||CD-adapco||0||September 17, 2008 11:28|
|cyclic boundaries||gosia stein||CD-adapco||5||June 13, 2007 07:39|
|Cyclic boundaries||sampaio||Open Source Meshers: Gmsh, Netgen, CGNS, ...||1||February 7, 2006 14:26|
|CYCLIC BOUNDARIES MATCHING||robert||CD-adapco||3||September 7, 2000 01:08|