|
[Sponsors] |
[OpenFOAM] Visualizing face normals in ParaView |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 18, 2006, 01:30 |
Visualizing face normals in ParaView
|
#1 |
New Member
Nikunj Raghuvanshi
Join Date: Mar 2009
Location: Chapel Hill, NC
Posts: 1
Rep Power: 0 |
Hi guys, I am using a hand-coded translator for porting in a tetrahedral mesh into an OpenFOAM polyMesh. I ran checkMesh and its reporting problems with incorrectly oriented face normals and I was wondering if there is away of visualizaing the face normals in ParaView (based on the order in which the vertices are listed for a face)?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM] Visualizing checkMesh results in Paraview | Claudio | ParaView | 15 | July 21, 2020 13:58 |
[DesignModeler] Find face normals to selected faces | Pallati | ANSYS Meshing & Geometry | 1 | July 26, 2017 11:04 |
channelFoam for a 3D pipe | AlmostSurelyRob | OpenFOAM | 3 | June 24, 2011 13:06 |
Segmentation fault when visualizing in ParaView | fsalvucci | OpenFOAM | 9 | July 30, 2010 15:39 |
gmsh2ToFoam | sarajags_89 | OpenFOAM | 0 | November 24, 2009 22:50 |