|August 5, 2014, 07:27||
How to modify postChannel in a way that it can be applied for a square channel
I wanna modify the postChannel utility in a way that I can use it for a square channel. one of the limitation of postChannel is that it assume that the mesh is periodic in the x and z directions. In my case, I have just a periodic condition in z direction. I wanna plot rms velocities on a line for example placed at x=0.1.
Here is the postChannel.C
my problem is that I know what to do but I don't know how to do!!!!!
Is anyone here who knows from where I should start and how can I modify this utility?
any hints or tips would be appreciated.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Compile OF 2.3 on Mac OS X .... the patch||gschaider||OpenFOAM Installation on Windows, Mac and other Unsupported Platforms||108||Today 08:56|
|Code for EARSM by Hellsten and RSM by Manceau, square duct, 2d turbulent channel||Thomas Baumann||OpenFOAM Running, Solving & CFD||8||August 4, 2014 15:23|
|transient motion of sphere in a square channel||sajeesh||FLUENT||0||March 4, 2013 10:15|
|How to make a UDF to have a velocity profile in a square channel||Gigis||Fluent UDF and Scheme Programming||8||January 13, 2013 22:20|
|Slug flow in square channel||PaulC||FLUENT||0||December 5, 2005 02:03|