 |
 |
 |
|
|
|
[Sponsors] | ||||
August 7, 2012, 11:52
|
Creating nonOrtho faceSet
|
#1 |
|
New Member
Join Date: Jul 2010
Posts: 16
Rep Power: 4  |
Dear readers,
I would like to extract faces from a mesh for which orthogonality is above a given value. This is exactly what is done by checkMesh but I want to set the non orthogonality input. I have had a look at the setSet utility but I didn't manage to do that. Neither I have found a way to change checkMesh behavior. How can I [simply] do that ? Thanks |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fluent3DMeshToFoam | simvun | OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ... | 48 | May 14, 2012 05:20 |
| Mass flow rate through faceSet using swak4foam | CedricVH | OpenFOAM | 5 | May 4, 2012 07:57 |
| Problem in running ICEM grid in Openfoam | Tarak | OpenFOAM | 6 | September 9, 2011 17:51 |
| creating faceSet | ganeshv | OpenFOAM Mesh Utilities | 1 | June 15, 2011 09:13 |
| Problems with Meshing: Collapsed Cells | Emmanuel Resch | CD-adapco | 1 | July 30, 2007 03:02 |
Linear Mode
