|
[Sponsors] |
Problem regarding the setting up of rhoReactingBuoyantFoam with wind |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 15, 2021, 08:27 |
Problem regarding the setting up of rhoReactingBuoyantFoam with wind
|
#1 |
New Member
Akshay
Join Date: Jan 2020
Posts: 28
Rep Power: 6 |
I am setting up the case for dispersion of one gas into another, for the no wind (that is 0 m/s), I am getting some acceptable simulation results.
So basically I am using Open Foam version 8 and I am trying to simulate the case where in H2 gas disperses into air. I am using rhoReacingBuoyantFoam with no reaction and no combustion for this case. If I want to simulate the case with certain winds speed should I allocate interfield of U with the desirable wind speed or should I create a separate inlet in my domain and specify the wind speed at this patch, then wait for this simulation and then let the H2 through another inlet. (for this case should i give internalfield in U) Presently my case is a 2D simulation with only inlet which is dischaging hydrogen into the air present in the large domain. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem in parallel processing [Process affinity not being set] | Roh | FLUENT | 4 | October 26, 2023 03:42 |
Problem with forces and moment calculated for wind turbine blade using simpleFoam | mostafa kamal | OpenFOAM Running, Solving & CFD | 2 | September 21, 2021 17:33 |
Dynamic mesh setting problem | Youwu | FLUENT | 7 | June 1, 2020 05:47 |
SU2-7.0.1 on ubuntu 18.04 | hyunko | SU2 Installation | 7 | March 16, 2020 04:37 |
A problem about setting boundary conditions | lyang | Main CFD Forum | 0 | September 19, 1999 18:29 |