[j.lisanti]

Hello.
I am attempting to mesh a 5 deg wedge of a cylinder in ICEM CFD and convert it to OpenFOAM format using fluent3DMeshToFoam. When I do this and adjust the appropriate boundary conditions and run checkMesh I get the following during the geometry check:

Checking geometry...
Overall domain bounding box (-20 -2.44696e-15 -0.177269) (0 4.064 0.177269)
Mesh (non-empty, non-wedge) directions (1 1 0)
Mesh (non-empty) directions (1 1 1)
Wedge FRONT with angle 2.5 degrees
***Cannot find opposite wedge for wedge FRONT
Boundary openness (4.62186e-18 -1.66095e-16 -2.69112e-14) OK.
Max cell openness = 3.09836e-16 OK.
Max aspect ratio = 6.69061 OK.
Minumum face area = 5.62568e-06. Maximum face area = 1.28406. Face area magnitudes OK.
Min volume = 1.07578e-08. Max volume = 0.0697424. Total volume = 13.247. Cell volumes OK.
Mesh non-orthogonality Max: 79.5003 average: 16.8294
*Number of severely non-orthogonal faces: 30.
Non-orthogonality check OK.
<<Writing 30 non-orthogonal faces to set nonOrthoFaces
Face pyramids OK.
Max skewness = 1.47 OK.
Coupled point location match (average 0) OK.

Failed 1 mesh checks.

I am unable to resolve this issue. Thank you in advanced for any assistance you may be able to provide. I look forward to contributing to this forum.

I am happy to provide additional details if necessary.