|
[Sponsors] |
inlet boundary condition based on specified water level |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 28, 2013, 15:37 |
inlet boundary condition based on specified water level
|
#1 |
Member
Hale
Join Date: May 2013
Posts: 53
Rep Power: 13 |
Hi,
I am dealing with a two phase flow problem where I need to specify a constant water level for the inlet. I do not want to do it by specifying a velocity or flux. I tried to do it by specifying a hydrostatic pressure (rho*g*h) for p_rgh and zeroGradient for U but it blows up! Is there any way to specify the height of the water at the inlet? Thanks Hale |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Time dependant pressure boundary condition | yosuke1984 | OpenFOAM Verification & Validation | 3 | May 6, 2015 06:16 |
Low Mixing time Problem | Mavier | CFX | 5 | April 29, 2013 00:00 |
[snappyHexMesh] Boundary layer in a pipe | Clementhuon | OpenFOAM Meshing & Mesh Conversion | 6 | March 12, 2012 12:41 |
Velocity inlet boundary condition for porous medium | Chander | CFX | 3 | March 11, 2012 21:18 |
Help for setting 3D boundary condition in compressing water vapor | sogolf | FLUENT | 0 | September 27, 2009 15:05 |