|November 22, 2013, 02:38||
Dents in mesh with addLayers
Join Date: Sep 2009
Posts: 18Rep Power: 8
I am using openfoam 2.2.x for creating mesh using snappy tool.
When attempting to create layers around a square part which is located inside a duct, I see some dents / missing elements in the mesh along the edges of the duct.
The dents are seen only when addLayers is used as there are not dents after the snapping step (i.e., the mesh in '2' folder has no dents but mesh in '3' folder has dents - see attached pictures).
Any ideas ? Please help. Thanks.
|addlayers, missing cells, snappyhexmesh|
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] surface mesh merging problem||everest||ANSYS Meshing & Geometry||44||April 14, 2016 06:41|
|Add Mesh Layers doesnt work on the whole surface||Kryo||OpenFOAM Native Meshers: snappyHexMesh and Others||8||September 13, 2012 09:28|
|Converting Starccm+ mesh||Ladnam||OpenFOAM||0||September 14, 2011 06:30|
|Mesh becoming coarser during addLayers in sHM||Arnoldinho||OpenFOAM Native Meshers: snappyHexMesh and Others||4||April 6, 2011 12:20|
|basic of mesh refinement||arya||CFX||4||June 19, 2007 12:21|