 |
 |
 |
|
|
|
[Sponsors] | ||||
December 2, 2009, 11:10
|
FOAM exiting >> "Error Code"
|
#1 |
|
New Member
Markus Golbs Hamm AG
Join Date: Nov 2009
Posts: 26
Rep Power: 5  |
Hello,
by testing simpleFoam I'm a problem by solving. Under icoFoam the modell are runnig fine. But under simpleFoam i'have big problems. Where can I look for errors or mistake's? In terminal are: linearUpwindV UMISTV limitedLinear skewCorrected linear UMIST reverseLinear filteredLinear2V weighted blended MCV cubic OSPRE ) file: /opt/OpenFOAM/caelinux-1.4.1/run/hd90-110-turbulent/system/fvSchemes::div(phi,U) at line 42. From function surfaceInterpolationScheme<Type>::New(const fvMesh&, const surfaceScalarField&, Istream&) in file lnInclude/surfaceInterpolationScheme.C at line 135. FOAM exiting Where should I beginn to search for? Greeting Markus |
|
|
|
|
|
December 3, 2009, 23:46
|
|
#2 |
|
Senior Member
Gijsbert Wierink
Join Date: Mar 2009
Posts: 382
Rep Power: 7 |
Hi Markus,
It seems you have a wrong div scheme for div(phi,U) in fvSchemes. Change it to one of the suggested schemes, "linear" is usually a save bet to start with.
__________________
Regards, Gijs |
|
|
|
|
|
|
December 8, 2009, 06:25
|
|
#3 |
|
New Member
Markus Golbs Hamm AG
Join Date: Nov 2009
Posts: 26
Rep Power: 5 |
Hello,
thank's. Markus |
|
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CGNS converters available | mbeaudoin | OpenFOAM Meshing & Mesh Conversion | 123 | April 9, 2013 09:53 |
| BlockMesh FOAM warning | gaottino | OpenFOAM Native Meshers: blockMesh | 7 | July 19, 2010 14:11 |
| Problem with rhoSimpleFoam | matteo_gautero | OpenFOAM Running, Solving & CFD | 0 | February 28, 2008 06:51 |
| Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Native Meshers: blockMesh | 10 | April 2, 2007 14:00 |
| Import gmsh msh to Foam | adorean | Open Source Meshers: Gmsh, Netgen, CGNS, ... | 24 | April 27, 2005 08:19 |
Linear Mode
