 |
 |
 |
|
|
|
[Sponsors] | ||||
June 15, 2012, 09:51
|
Interpolation from particles (points) to vol
|
#1 |
|
New Member
Join Date: Mar 2010
Posts: 27
Rep Power: 16  |
Dear Foamers,
I am looking for a possibility to interpolate values from lagrangian particles to the mesh volumes. Each parctile holds a separate value, such as a weight or whatever. What I need is an area-weighted field of all particles (many of them!). One possibilty would be to loop over all cells (or particles) and just average the values of all particles within one cell. However, the area-weighting is lost by doing this. As far as I see it, the class pointVolInterpolation "only" interpolates from a full pointMesh to a volMesh and cannot be used for my problem. Am I right? Any ideas? Thanks in advance! |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Interpolation between faces and points of a polyPatch | hartinger | OpenFOAM Running, Solving & CFD | 12 | March 7, 2016 13:08 |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
| trying to simulate two-phase jet flow with particles in surface injection | ajkratos | FLUENT | 5 | March 3, 2015 21:33 |
| [blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 07:36 |
| Natural convection - Inlet boundary condition | max91 | CFX | 1 | July 29, 2008 20:28 |
Threaded Mode
