|
[Sponsors] |
[swak4Foam] in parallel (massflow on a faceZone)? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 10, 2013, 08:34 |
in parallel (massflow on a faceZone)?
|
#1 |
Senior Member
Join Date: Oct 2009
Posts: 140
Rep Power: 16 |
Hi Foamers!
Does swak4Foam work in parallel? I would like to sample the massflow on an internal faceZone, which is distributed on several processors! Has anyone of you done it so far and like to share his/her experiences? Cheers Peter |
|
January 10, 2013, 09:27 |
|
#2 | |
Assistant Moderator
Bernhard Gschaider
Join Date: Mar 2009
Posts: 4,225
Rep Power: 51 |
In general yes. The parts that I KNOW that they are not parallel usually fail with an error
Quote:
To convince yourself that it works have a look at the Examples/other/angledDuctImplicit case and the entries flowBeforeZone and flowAfterZone. Run the case in serial and parallel and see if the numbers are the same
__________________
Note: I don't use "Friend"-feature on this forum out of principle. Ah. And by the way: I'm not on Facebook either. So don't be offended if I don't accept your invitation/friend request |
||
January 14, 2013, 08:48 |
|
#3 |
Senior Member
Join Date: Oct 2009
Posts: 140
Rep Power: 16 |
Thank you very much.
I ll try it and post my results. cheers peter |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with Application based on a faceZone in parallel | psilkeit | OpenFOAM Programming & Development | 2 | April 28, 2016 09:47 |
Explicitly filtered LES | saeedi | Main CFD Forum | 16 | October 14, 2015 11:58 |
simpleFoam parallel | AndrewMortimer | OpenFOAM Running, Solving & CFD | 12 | August 7, 2015 18:45 |
Reconstructing undecomposed faceZone in parallel | cliffoi | OpenFOAM Programming & Development | 1 | August 30, 2013 10:29 |
[swak4Foam] Mass flow through faceZone using swak4foam when running in parallel | billie | OpenFOAM Community Contributions | 22 | May 14, 2013 07:20 |