|
[Sponsors] |
How to deal with a rotating shaft which is not in the rotating zone. |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 5, 2013, 20:00 |
How to deal with a rotating shaft which is not in the rotating zone.
|
#1 |
Senior Member
Dongyue Li
Join Date: Jun 2012
Location: Beijing, China
Posts: 838
Rep Power: 17 |
Hi FOAMERS,
In this situation depicted in the image.the up impeller and the bottom impeller are in the rotating zone(I represent the rotating zone using two boxes).But the shaft actually is rotating. How should I deal with this boundary condition without making the shaft embodied in the rotating zone? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Mesh conversion problem (fluent3DMeshToFoam) | Aadhavan | OpenFOAM Meshing & Mesh Conversion | 2 | March 8, 2018 01:47 |
[GAMBIT] periodic faces not matching | Aadhavan | ANSYS Meshing & Geometry | 6 | August 31, 2013 11:25 |
[Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem | Attesz | OpenFOAM Meshing & Mesh Conversion | 12 | May 2, 2013 10:52 |
Problem in running ICEM grid in Openfoam | Tarak | OpenFOAM | 6 | September 9, 2011 17:51 |
Problem in IMPORT of ICEM input file in FLUENT | csvirume | FLUENT | 2 | September 9, 2009 01:08 |