|July 9, 2013, 03:07||
Defining mesh motion diffusivity from file
Join Date: Oct 2012
Posts: 17Rep Power: 4
I am looking for a sample case where the mesh motion diffusivity (using laplaceFaceDecomposition) is defined from file for each point in the mesh?
You may think my case as a shoebox where the top stands still and bottom moves. My mesh is finer at the bottom.
Short side walls of this box are my inlet and outlet boundaries and the long side walls are the slip boundaries.
Thanks for the replies
|July 9, 2013, 04:14||
Join Date: May 2009
Location: Delft, Netherlands
Posts: 921Rep Power: 17
I don't know a tutorial case, but from what I can tell (looking at the code in 1.6-ext) the diffusivity is defined as a surfaceScalarField, i.e. per face. I'm not sure if there is a tool to set values on a surfaceScalarField (such as setFields for vol*Fields), but if there isn't it wouldn't be too hard to write a small tool specifically for your case.
*On twitter @akidTwit
*Spend as much time formulating your questions as you expect people to spend on their answer.
*Help define the OpenFOAM stackexchange Q&A site: http://area51.stackexchange.com/prop...oam-technology
|February 12, 2015, 06:00||
Join Date: Feb 2014
Posts: 7Rep Power: 3
I am also looking for a sample case - did you found one?
Do you have another solution or workaround?
|Thread||Thread Starter||Forum||Replies||Last Post|
|swak4Foam-groovyBC build problem||zxj160||OpenFOAM||18||July 30, 2013 13:14|
|build problem swak4Foam OF 2.2.0||mcathela||OpenFOAM Installation||14||April 23, 2013 13:59|
|funkySetFields compilation error||tayo||OpenFOAM||39||December 3, 2012 06:18|
|error message with modeling a cube with a hold at the center||hsingtzu||OpenFOAM Native Meshers: blockMesh||2||March 14, 2012 10:56|
|mesh airfoil NACA0012||anand_30||OpenFOAM Meshing & Mesh Conversion||12||December 12, 2011 05:16|