|
[Sponsors] |
is there anyone out there who has used the Sliding Interface in cases where the two s |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 14, 2014, 03:12 |
is there anyone out there who has used the Sliding Interface in cases where the two s
|
#1 |
New Member
xyt
Join Date: Feb 2014
Posts: 7
Rep Power: 12 |
in linearValveFvMesh,how can i get it work,my case is two blockmesh.
thanks Last edited by xyt; May 14, 2014 at 03:14. Reason: used the Sliding Interface in cases where the two sliding patches are completely separate from one another |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
[Other] Sliding interface tutorial | davidmd | OpenFOAM Meshing & Mesh Conversion | 0 | May 16, 2013 06:46 |
[Other] An appropriate Mesher for creating sliding interface | sasanghomi | OpenFOAM Meshing & Mesh Conversion | 2 | May 5, 2013 15:24 |
Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |