apparent anomalies at ACMI interface - Page 2 -- CFD Online Discussion Forums

July 23, 2018, 09:19

#21

Anouk

New Member

Join Date: Jan 2018

Posts: 12

Rep Power: 8

I made the mesh with gmsh, but that is not the issue here. The issue is that I have set the boundary condition on the ACMI blockage patch as "rototingWallVelocity", which is possible apparently, but doesn't work as intended according to wyldckat:

Quote:

the blockage entries must strictly be set to fixed value and they will not work as intended with anything else

It would be good to have this documented in the OpenFOAM documentation, for future reference, instead of just in a post in this forum...

Tobi likes this.

Page 2 of 2

Tags

acmi, moving mesh., rhopimpledymfoam

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
Wind turbine simulation	Saturn	CFX	58	July 3, 2020 01:13
Question about heat transfer coefficient setting for CFX	Anna Tian	CFX	1	June 16, 2013 06:28
Error finding variable "THERMX"	sunilpatil	CFX	8	April 26, 2013 07:00
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 04:05

All times are GMT -4. The time now is 23:15.