[uli_u]

Hi,

first of all thanks for this great toolset!

I have finished to set up a case to simulate the steady compressible turbulent flow through a manifold (1 inlet, 1 outlet) with rhoSimpleFoam. The goal is to estimate the massflow through the geometry by specifying:

Inlet: Total pressure 1bar, Temperature 293.15K
outlet: Static pressure, 0.9bar

Everything seems be fine but I have still the problem of defining the right BC for this setup.
What should be specified at the inlet to reflect the above BC?

Thanks for any help,

regards
Uli