 |
 |
 |
|
|
|
[Sponsors] | ||||
September 14, 2023, 02:52
|
Use Swirl Injection in sprayFOAM
|
#1 |
|
New Member
Pan,zongyu
Join Date: Jul 2022
Posts: 4
Rep Power: 3  |
Hello all,
I am new to CFD.Recently, I was trying to perform some high-pressure swirl spray combustion simulations. I used the sprayFOAM solver in openFOAM-2212. However, after studying various model selections, I found that the injector model only contains coneNozzleInjection and manualInjection, etc., and after searching for information, I found that the old The dieselFoam version contains a swirlinjector model, but sprayFoam does not. Is there any way to achieve high-pressure swirl spray in sprayFoam? please help me, any suggestions are welcome. thanks, With Best Regard. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sprayFoam hangs during parcel injection | sammy1 | OpenFOAM Running, Solving & CFD | 6 | May 29, 2023 08:02 |
| Two fuel injection for combustion inside a LPRE using sprayFoam. | kanishque | OpenFOAM Running, Solving & CFD | 1 | November 11, 2022 05:32 |
| file injection.: continuity fail; volume injection.: wrong total mass | blerli_91 | Fluent Multiphase | 6 | October 2, 2018 05:34 |
| injection problem | Mark New | FLUENT | 0 | August 4, 2013 01:30 |
| Definition of swirl fraction for hollow cone injection in Fluent | launchpad | FLUENT | 0 | June 30, 2011 03:22 |
Linear Mode
