 |
 |
 |
|
|
|
[Sponsors] | ||||
December 15, 2008, 18:22
|
Hallo, all
I have tried mixer
|
#1 |
|
Member
Hai Yu
Join Date: Mar 2009
Location: OvgU, Magdeburg
Posts: 64
Rep Power: 6  |
Hallo, all
I have tried mixer2D using icoDyMFoam, and it already worked well for me. Now, I am doing my own case, and I was wondering about the "patch insideSlider" and "patch outsideSlide" two items in blockMeshDict: 1, Should the interface between the stativ and moving parts be of thickness or not? 2, if no, should I double the vertices at each position on the interface, and set half to insideSlider and the other half to outsideSlider? 3, if yes, is there any suggestions for the thickness? 4, And, is there any suggestion about setting up the geometry by Gambit, with least manuel editing effort after conversion. What kind of attribute is better for the interface? Thx alot in advance! |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Graphical viewer for blockMeshDict | grtabor | OpenFOAM Pre-Processing | 22 | March 14, 2013 04:05 |
| BlockMeshDict with multiple hex blocks mergePatchPairs | prousa | OpenFOAM Native Meshers: blockMesh | 1 | May 14, 2009 23:42 |
| MergePatchPairs in blockMeshDict | lord_kossity | OpenFOAM Native Meshers: blockMesh | 0 | April 15, 2008 02:28 |
| BlockMeshDict keywords | msrinath80 | OpenFOAM Native Meshers: blockMesh | 2 | September 20, 2007 09:14 |
| Trouble with my first blockMeshDict file | osimonsimon | OpenFOAM Native Meshers: blockMesh | 1 | October 13, 2006 14:32 |
Linear Mode
