[aidan_wilky]

Hello,
I am fairly new to openfoam and have to complete a DMD visualisation of an airfoil on openfoam 2212. To do so I copied the Cylinder2D case files however in relation to the 2D airfoil Openfoam example. I have got to the point where this error (shown below) appears when the simulation reaches around 10 seconds. I have tried changing multiple things around but I dont know what this error message means. Does anyone have any feedback or help?
both errors are from pimplefoam log files
[(1ERROR)
[1]
[1]
[1] --> FOAM FATAL ERROR: (openfoam-2212)
[1] cannot find file "/home/aidanwilky5/runs/DMD0/processor1/1.008/p"
[1]
[1] From virtual Foam::autoPtr<Foam::ISstream> Foam::fileOperations::uncollatedFileOperation::rea dStream(Foam::regIOobject&, const Foam::fileName&, const Foam::word&, bool) const
[1] in file global/fileOperations/uncollatedFileOperation/uncollatedFileOperation.C at line 561.
[1]
FOAM parallel run exiting
[1]
Reading field p

[0]
[0]
[0] --> FOAM FATAL ERROR: (openfoam-2212)
[0] cannot find file "/home/aidanwilky5/runs/DMD0/processor0/1.008/p"
[0]
[0] From virtual Foam::autoPtr<Foam::ISstream> Foam::fileOperations::uncollatedFileOperation::rea dStream(Foam::regIOobject&, const Foam::fileName&, const Foam::word&, bool) const
[0] in file global/fileOperations/uncollatedFileOperation/uncollatedFileOperation.C at line 561.
[0]
FOAM parallel run exiting
[0]
--------------------------------------------------------------------------
MPI_ABORT was invoked on rank 0 in communicator MPI_COMM_WORLD
with errorcode 1.
(2) error
DMD stdmd57 write:
--> FOAM Warning :
From virtual bool Foam::functionObjects:MD::end()
in file DMD/DMD.C at line 238
DMD needs at least three snapshots to produce output
Only 2 snapshots are available
Skipping DMD output calculation and write