|October 19, 2009, 10:46||
engine-mesh, layer removal?
Join Date: Oct 2009
Posts: 1Rep Power: 0
I made a case to run with dieselEngineFoam(kivaTest+aachenBomb). Everything is ok but mesh. I started the simulation at BDC. At TDC I have a deformed mesh with the same number of cells. There is no layer removal.
-would you please guide me to set the case correctly.
-should I change the code or do any pre-processing?
|October 20, 2009, 03:22||
Join Date: Jun 2009
Posts: 36Rep Power: 9
u have to implement the engineTopoChangerMesh class
engineTopoChangerMesh layerAR; instead of
in the engineGeometry file. Define delta and offset and min/maxlayerthickness for your calculation. That should be almost all.
If u have more questions please search for papers from Tommaso Lucchini.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Dynamic Mesh with Boundary Layer||Marcell||FLUENT||0||March 11, 2009 09:40|
|Convergence moving mesh||lr103476||OpenFOAM Running, Solving & CFD||30||November 19, 2007 15:09|
|Need help to mesh Wankel engine||Sam||Main CFD Forum||3||October 4, 2007 20:33|
|3D mesh with boundary layer||fra76||OpenFOAM Meshing Format & General Technical||0||May 21, 2006 03:32|
|boundary layer mesh||merac||FLUENT||1||June 19, 2001 11:45|