|August 22, 2011, 09:25||
Join Date: Aug 2011
Posts: 3Rep Power: 6
I am about to start up on the icoFsiFoam. I read so much about the FSI benchmark by Turek&Hron. Is there any place where I can download it in a ready to use setup that just needs some changing?
If not which, tools would you recommend for setting up the case? I assume that it would save some time to just take the cylinder and add the little flag to it.
Thanks in advance
|July 2, 2014, 07:05||
Join Date: Jun 2011
Posts: 69Rep Power: 6
|benchmark, case setup, fsi|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Needed Benchmark Problems for FSI||Mechstud||Main CFD Forum||4||July 26, 2011 12:13|
|Euler3d Benchmark||Verdi||Hardware||2||May 26, 2011 06:21|
|BCs in an FSI simulation of a flexble pipe||vivekcfd||OpenFOAM||10||January 8, 2010 05:14|
|FSI Benchmark for Laminar Flows||ybams||Main CFD Forum||0||August 5, 2009 16:57|
|how to extend FSI 2D codes to 3D, need advises||abouziar||Main CFD Forum||1||May 30, 2008 04:08|