|
[Sponsors] |
December 29, 2011, 04:32 |
Problem using AMI
|
#1 |
Senior Member
Vincent RIVOLA
Join Date: Mar 2009
Location: France
Posts: 283
Rep Power: 18 |
Dear all,
It's been a while since I did not post on the forum, but I am still following with attention the new developments. I tried to use the AMI feature with pimpleDymFoam on the tutorial propeller. It works perfectly and look very promising. So I decided I would try it on one of my own model, and see what I get. Unfortunately, it always break up at some point whatever I use for the max courant number, or the relaxation factors, or many different things I tried. I just notice that the last time step writes the following lines: Code:
solidBodyMotionFunctions::rotatingMotion::transformation(): Time = 0.00123617 transformation: ((0 0 0) (0.981207 (0 0 0.192959))) AMI: Creating addressing and weights between 23366 source faces and 23366 target faces AMI: Patch source weights min/max/average = 0.000261522, 1.75988, 1.00123 AMI: Patch target weights min/max/average = 0, 1.3569, 1.00084 PIMPLE: iteration 1 Thanks in advance for your advice. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |