|
[Sponsors] |
May 9, 2012, 01:00 |
|
#11 |
Senior Member
cfdkid
Join Date: Mar 2009
Posts: 133
Rep Power: 17 |
Hi linnemann,
Thank you for reply. Same case after modification you suggested is here: http://dl.dropbox.com/u/70019943/roCube2.tar.gz Yes you are right i do not need changeDict file (silly on my part even after understanding i tried to use it as it made Solver to run ). Now when i change manually : splitMeshRegions -makeCellZones -overwrite This gives error as under. Now the good part is this "weights between 1380 source faces and 1504 target". Is there something i am terribly missing???? HTML Code:
Reading volScalarField cellToRegion
Reading volScalarField p
AMI: Creating addressing and weights between 1380 source faces and 1504 target faces
--> FOAM FATAL ERROR:
Unable to set source and target faces
From function void Foam::cyclicAMIPolyPatch::setNextFaces(label&, label&, const primitivePatch&, const primitivePatch&, const boolList&, labelList&, const DynamicList<label>&) const
in file lnInclude/AMIInterpolation.C at line 878.
FOAM aborting
#0 Foam::error::printStack(Foam::Ostream&) in "/home/chandra/OpenFOAM/OpenFOAM-2.1.x/platforms/linux64GccDPOpt/lib/libOpenFOAM.so"
__________________
________________________________________ Regards, CFDkid It never gets easier You just get Better |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |