|
[Sponsors] |
|
March 12, 2012, 16:57 |
Restart using different boundary conditions
|
#1 |
Senior Member
Attesz
Join Date: Mar 2009
Location: Munich
Posts: 368
Rep Power: 17 |
Hi all,
what is the best way if I want to restart the simulation but I have new BC types and values? mapping or can I change it in the results file? I have 15M cells so opening a result file is not so straightforward :P Best, |
|
March 13, 2012, 01:58 |
|
#2 |
Senior Member
Niels Nielsen
Join Date: Mar 2009
Location: NJ - Denmark
Posts: 555
Rep Power: 27 |
Hi.
As you said either you map or you use some clever sed/regex that does search and replace in the result files. Sed would probably be faster since mapping 15M cells can take quite some time. Best
__________________
Linnemann PS. I do not do personal support, so please post in the forums. |
|
March 13, 2012, 04:29 |
|
#3 |
Senior Member
Martin
Join Date: Oct 2009
Location: Aachen, Germany
Posts: 255
Rep Power: 21 |
Hi,
the "changeDictionary" utility with an appropriate changeDictionaryDict might be a good choice, too. Martin |
|
March 13, 2012, 04:35 |
|
#4 |
Senior Member
Attesz
Join Date: Mar 2009
Location: Munich
Posts: 368
Rep Power: 17 |
Thank you all! I'll have a look at the changeDictionary utility!
Best regards, Attila |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mesh file for flow over a circular cylinder | Ardalan | Main CFD Forum | 7 | December 15, 2020 13:06 |
Impinging Jet Boundary Conditions | Anindya | Main CFD Forum | 25 | February 27, 2016 12:58 |
symmetry boundary conditions in cfx | lost.identity | CFX | 41 | May 22, 2013 07:21 |
restart after changing boundary conditions | aperrone | STAR-CD | 5 | April 25, 2011 20:53 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |