|April 2, 2013, 07:11||
Help with tutorial
Join Date: Apr 2013
Posts: 11Rep Power: 4
I am looking for some guidance on openFOAM MS (openfoam desinger v 1.0) . I am new to OpenFOAM and I have been following the tutorial case cavity, but have had problems when running paraview. I was able generate the mesh and paraview loaded fine but I am not able to load any files of this tutorial into paraview. I am running openFOAM under win7, 64bit bootcamped Mac.
Thanks, any help is greatly apreciated.
|openfoam ms paraview|
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ANSYS Meshing] I need tutorial files||colorful||ANSYS Meshing & Geometry||5||September 19, 2014 01:21|
|Tutorial for subcooled nucleate boiling||Asghari||FLUENT||34||September 27, 2013 04:58|
|Problem on Fluent Tutorial: Horizontal Film Boilig||Feng||FLUENT||2||April 13, 2013 05:34|
|[Virtualization] OpenFOAM oriented tutorial on using VMware Player - support thread||wyldckat||OpenFOAM Installation||2||July 11, 2012 16:01|
|Rotor/stator tutorial, and how to...||gilberto||CFX||5||January 21, 2002 10:41|